江阴市新安粉体设备有限公司联系电话

Jiangyin Xinan Machinery Manufacturing Co.,Ltd.

Address:8 Xin'an Road Town, Jiangyin City, Jiangsu Zhu Yun Gu Road Industrial Park

Phone:0510-86384831

Fax:0510-86393733

Phone:13151025777

E-mail:xinanfenti@foxmail.com

News

Your current location:HomePage > News > News

The proper use of feed mill

 l mill, long-term operation, should be fixed on the basis of cement. If the frequent changes in the workplace, the mill and the motor to be installed in the machine base made ​​with angle iron mill diesel powered, so that the two power matching, that is, the engine power is slightly larger than the mill power, and then the two by a pulley groove, the the pulley outer end surface on the same plane.

    Mill after installation to make sure that all fasteners fastening shall be tighten if loose.

    To check the belt tension is appropriate, whether the motor shaft and the mill shaft parallel.

    (4) before the start of the mill, the first turned by hand rotor, check the jaw, the hammer rotor operation is flexible and reliable, the shell without crashing, the rotation of the rotor is consistent with the machine direction of the arrow, motor and powder Nazi machine lubrication is good.

    Do not replace the pulley to prevent the speed is so high that the grinding chamber to produce an explosion, or the speed is too low to affect the work efficiency.

    Crushed start idle 3 minutes, then there is no anomaly feeding.

    7 work to pay attention to the functioning of the mill, the feed should be uniform, to prevent blocking stuffy car, not a long time overload. If it is found there is vibration, noise, the bearing body temperature is too high, spray material out phenomenon, should immediately stop and check troubleshooting before they can continue to work.

    Crushed material should be carefully examined, in order to avoid copper, iron, stones and other hard objects into the grinding chamber causing the accident.

Operator not to wear gloves, should be standing on the side of the mill feed, to prevent rebound debris from injuring facial.

Manufacturers products

Mixer Manufacturers Trough mixer Ribbon mixer Food mill Grinder manufacturers High Efficient Mill Herbal pulverizer Micro Pulverizer Universal grinder

© Copyright Jiangyin Xinan Machinery Manufacturing Co.,Ltd. Address:8 Xin'an Road Town, Jiangyin City, Jiangsu Zhu Yun Gu Road Industrial Park Phone:0510-86384831 13151025777 Fax: 0510-86393733
Support:Shanghai Jiu Yi Network Technology Co., Ltd. Jiangyin Branch
Our Keywords:Universal grinder Micro Pulverizer Herbal pulverizer High Efficient Mill Grinder manufacturers Food mill Ribbon mixer Trough mixer